Filter
Top Products
Connect all the sources to the DVI inputs on the 4x4 HDTV Matrix, using the
supplied cables.
Connect the HDMI/DVI displays to the outputs on the 4x4 HDTV Matrix.
Connect the 24VDC powersupply to the 4x4 HDTV Matrix
Controlling the 4x4 HDTV Matrix using the RMT16-IR:
Pressing Buttons... Switches...
1-4 Display 1 to view Source 1, 2, 3, or 4
5-8 Display 2 to view Source 1, 2, 3, or 4
9-12 Display 3 to view Source 1, 2, 3, or 4
13-16 Display 4 to view Source 1, 2, 3, or 4
*Note for computers connected to the HDTV Matrix - When your computer
boots up, it looks for an EDID (extended display identifi cation data) from the dis-
play to tell it what monitor is connected and what resolution to output. During boot
up of the computer you should have ONLY one output selected to one input at a
time so that the computer gets the EDID of the display that is selected. If you have
multiple outputs selected to one computer, the computer will read the EDID of the
last output selected to it. If all your displays are the same, or all displays are ca-
pable of running at the same resolution then this step does not matter.
You can also use a DVI Detective to illiminate the need to have that matrix selected
to the computer during bootup.
USING THE 4X4 HDTV MATRIX
1
2
3
4
4