"''"
BdYZa<%,%+B[\#h^cXZ&&$%.
Squaring Stock
Squaring stock involves four steps performed
in the following order:
1. Surface Plane on the Jointer: I]ZXdcXVkZ
[VXZ d[ i]Z ldg`e^ZXZ ^h hjg[VXZeaVcZY [aVi
l^i]i]Z_d^ciZghZZFigure 21#
Figure 21.Hjg[VXZeaVc^c\dci]Z_d^ciZg#
2. Surface Plane on a Thickness Planer:
I]Z deedh^iZ [VXZ d[ i]Z ldg`e^ZXZ ^h hjg"
[VXZeaVcZY[aVil^i]Vi]^X`cZhheaVcZghZZ
Figure 22#
EgZk^djhan
Hjg[VXZ
EaVcZY;VXZ
Figure 22.Hjg[VXZeaVc^c\dcVi]^X`cZhh
eaVcZg#
3. Edge Joint on the Jointer: I]Z XdcXVkZ
ZY\Zd[i]Zldg`e^ZXZ^h_d^ciZY[aVil^i]i]Z
_d^ciZghZZFigure 23#
Figure 23.:Y\Z_d^ci^c\dci]Z_d^ciZg#
4. Rip Cut on a Table Saw: I]Z_d^ciZYZY\Z
d[i]Zldg`e^ZXZ ^heaVXZYV\V^chi i]ZiVWaZ
hVl [ZcXZ VcY i]Z deedh^iZ ZY\Z ^h Xji d[[
hZZFigure 24#
EgZk^djhan
?d^ciZY:Y\Z
Figure 24.G^eXjii^c\dcViVWaZhVl#
Making adjustments to the jointer while the
machine is ON greatly increases the risk to
the operator from the rotating cutterhead.
ALWAYS make sure the jointer is OFF and
disconnected from power before performing
adjustments, maintenance, or service on the
machine!
