Filter
Top Products
TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
IMPORTANT SAFEGUARDS
: To reduce the risk of fire
and electric shock, do not remove the cover
(or back) of the unit. Refer servicing only to
qualified service personnel.
The lightning flash with arrowhead symbol, within an equilateral tri-
angle, is intended to alert the user to the presence of uninsulated
"dangerous voltage" within product's enclosure that may be of suffi-
cient magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operation and servicing
instructions in the literature accompanying the appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
In addition to the careful attention devoted to quality standards in the manu-
facture of your video product, safety is a major factor in the design of every
instrument. However, safety is your responsibility, too. This sheet lists impor-
tant information that will help to assure your enjoyment and proper use of the
video product and accessory equipment. Please read them carefully before
operation and using your video product.
CAUTION
Installation
Read and Follow Instructions- All the safety and operation instructions
should be read before the video product is operated. Follow all operating
instructions.
Retain Instructions- The safety and operating instructions should be retain-
ed for future reference.
Read all Warnings-Comply with all warnings on the video product and in the
operating instructions.
Polarization- This video product is equipped with a polarized alternating -
current line plug. This plug will fit into the power outlet, try reversing the
plug. If the plug still fails to fit, contact your electrician to replace your obs-
olete outlet. To prevent electric shock, do not use this polarized plug with an
extension cord, receptacle, or other outlet unless the blades can be fully in-
serted without blade exposure. If you need an extension cord, use a polariz-
ed cord.
Power Sources- This video product should be operated only from the type
of power source indicated on the marking label. If you are not sure of the
type of power supply to your home, consult your video dealer or local power
company. For video products intended to operate from battery power, or
other sources, refer to the operating instructions.
Overloading- Do not overload wall outlets or extension cords as this can
result in a risk of fire or electric shock. Overloaded AC outlets, extension
cords, frayed power cords, damaged or cracked wire insulation, and broken
plugs are dangerous, They may result in a shock or fire hazard. Periodically
examine the cord, and if its appearance indicated damage or deteriorated
insulation, have it replaced by your service technician.
Power-Cord Protection- Power-supply cords should be routed so that they
are not likely to be walked on or pinched by items placed upon or against
them, paying particular attention to cords at plugs, convenience receptacl-
es, and the point where they exit from the video product.
Ventilation- Slots and openings in the case are provided for ventilation to
ensure reliable operation of the video product and to protect it from over-
heating. These openings must not the blocked or covered. The openings
should never be blocked by placing the video product on a bed, sofa, rug,
or heat register. This video product should not be placed in a built-in insta-
llation such as a book case or rack, unless proper ventilation is provided or
the video product manufacturer's instructions have been followed.
Attachments- Do not use attachments unless recommended by the video
product manufacturer as they may cause hazards.
Water and Moisture- do not use this video product near water for example,
near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement,
or near a swimming pool and the like. Caution: Maintain electrical safety.
Powerline operated equipment or accessories connected to this unit should
bear safety certification mark on the accessory itself and should not be
modified so as to defeat the safety features. This will help avoid any
danger and should not be modified so as to defeat the safety features. This
will help avoid any potential hazard from electrical shock or fire. If in doubt,
contact qualified service personnel.
Accessories- Do not place this video product on an unstable cart, stand,
tripod, bracket, or table. The video product may fall, causing serious injury
to a child or adult as well as serious damage to the video product. Use this
video product only with a cart, stand, tripod, bracket, or table recommend-
ed by the manufacturer's or sold with the video product. Any mounting of
the product should follow the manufacturer's instructions and use of a
mounting accessory recommended by the manufacturer.
A video product and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the video product
and cart combination to overturn.
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to
Section 820-40 of the NEC which provides guidelines for proper grounding
and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as
practical.
Outdoor Antenna Grounding- If an outside antenna or cable system is
connected to the video product, be sure the antenna or cable system is
grounded so as to provide some protection against voltage surges and
builtup static charges. Section 810 of the National Electrical Code, ANSI
/NFPA No.70-1984 (Section 54 of Canadian Electrical Code, Part1) provi-
des information with respect to proper grounding of the mast and support-
ing structure, grounding of the lead-in wire to an antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding
electrode.
Power Lines-An outside antenna system should not be located in the vici-
nity of overhead power lines, other electric light or power circuits, or where
it can fall into such power lines or circuits. When installing an outside ant-
enna system, extreme care should be taken to keep from touching or app-
roaching such power lines or circuits, as contact with them might be fatal.
Installing an outdoor antenna can be hazardous and should be left to a
professional antenna installer.
Use
Cleaning- Unplug this video product from the wall outlet before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for clean-
ing.
Objects that may touch dangerous voltage points or "short-out" parts could
result in a fire or electric shock. Never spill liquid of any kind on the video
product.
Lightning-For added protection for this video product during a lightning
storm, or when it is left unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the antenna or cable system.
This will prevent damage to the video product due to lightning and power
line surges.
Service
Servicing-Do not attempt to service this video product yourself, as opening
or removing covers may expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Conditions requiring service-unplug this video product from the wall outlet,
refer servicing to qualified service personnel under the following conditions:
A. When the power-supply cord or plug is damaged.
B. If liquid has been spilled, or objects have fallen into the video product.
C. If the video product has been exposed to rain or water.
D. If the video does not operate normally by following the instruction manual.
Adjust only those controls that are covered by operating instructions.
Improper adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to restore the
video product to its normal operation.
E. If the video product has been dropped or cabinet has been damaged.
F. When the video product exhibits a distinct change in performance-this
indicates a need for service.
Replacement Parts-When replacement parts are required, have the service
technician verify that the replacements he uses have the same safety
characteristics as the original parts. Use of replacements specified by the
video product manufacturer can prevent fire, electric shock, or other hazards.
Safety Check-Upon completion of any service or repairs to this video pro-
duct, ask the service technician to perform safety checks recommended by
the manufacturer to determine that the video product is in safe operating
condition.
Wall or Ceiling Mounting- The product should be mounted to a wall or ceil-
ing only as recommended by the manufacturer.
Heat-The product should be situated away from heat sources such as
radiators, heat registers, stoves, or other products (including amplifiers)
that produce heat.
13.
22.
21.
20.
19.
18.
15.
11.
12.
14.
16.
17.
23.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
2
SAFETY INFORMATION