Filter
Top Products
14
2. Channel ‘1’ will appear on the left top corner of the screen after the
channel scanning is finished. Press the CH- or CH+ button to select the
previous or next channels or press the 0-9 buttons to enter a channel
number directly.
3. Press the button on the remote control to switch between the
present channel to the last channel was viewed.
4. Press the P.MODE button repeatedly to cycle through the available
video picture modes from the below different types
5. Press the S.MODE button repeatedly to cycle through the available
sound modes from the below different types
6. Press the MUTE button to cut off the sound output, press this button
again to resume sound output.
7. Press the DISPLAY button to display the preset channel information.
(3) View different input signal sources
Press the SOURCE button then press the or button to select the
available input sources as follow:
(4) View the TELETEXT program
1. Press the SOURCE button to select the DTV mode. Then press the CH-
or CH+ button on the remote control to select a DTV channel in order to
pick up the TELETEXT signal, if broadcast.
Standard Mild
User
Dynamic
ATV
AV
S-Video
YPBPR
DVD VGA
DTV
HDMI
Music
Movie Sports User
Standard