Filter
Top Products
Data Side
Basic Playback
Preparations
1. Place the DVD in the disc slot as figure above.
The disc will be loaded automatically after one to
two seconds, then the DVD player reads the DVD
and displays the opening menu. If there is no
disc placed on the disc slot in DVD mode, OPEN
will display on the screen all the times)
There is only one disc size can be loaded in
the disc slot .
Do not place a disc which is unplayable in
this DVD player.
Some disc may not playback automatically,
you can press PLAY button to start
playback.
2. Some disc may start playback with a menu,
use the cursor button on the remote control to
select menu options and press PLAY
to start, or press digits to select a menu
options directly.
1. Press PAUSE/STEP to pause playback (still
mode). The sound will be muted during still mode.
2. Press PLAY/ENTER to resume normal playback.
Pause playback
1. Press STOP button to go to stop mode, the
TV screen will show the start-up logo. For some
disc the player can recall the location where
stopped, such as DVDs and audio CDs.
2. Press PLAY to resume playback from the
location where playback is stopped.
3. Press STOP twice to stop completely.
Stop playback
Previous and Next
During playback, press PREV key can go
back to the beginning of this chapter, then each
press of this key will skip a chapter till the start of
the disc. (note: Disc function may vary
depending on disc format)
Each press of NEXT key during playback will
skip the current chapter and play the next one.
Fast forward and Fast reverse
1. Press FWD to fast forward through the disc.
Each time the FWD button is pressed, the fast
forward motion speed changes. It would cycle
through 2X, 4X, 8X, 16X, 32X and normal.
2. Press PLAY to resume normal playback.
3. Press REV to fast reverse through the disc.
Each time the REV button is pressed, the fast
reverse motion speed changes. It would cycle
through 2X, 4X, 8X, 16X, 32X and normal.
4. Press PLAY to resume normal playback.
Basic playback
1. Press the PAUSE/STEP button to pause the
playback.
2. To view the next frame, press the PAUSE/STEP
button. Each press of the PAUSE/STEP button
advances the film by one frame.
Single step playback
Basic Playback
Operate the remote to set the TV to DVD status.
Note: The unit do not allow enter DVD mode again
(or place a DVD in the disc slot)after it have just left
to avoid any damage of the DVD. Wait for 10 seconds
to enter again.
Press this button can zoom enlarge or lessen the picture.
Each time pressed the picture times will be change.
ZOOM
When pressing the D.CALL button repeatedly
different OSD indicator will be displayed for
different types of disc DVD, CD etc
D.CALL
In zoom mode press navigation buttons to move
the picture displayed on the screen