Filter
Top Products
Install the brace pole
M4X8rom the front .
1 After put the brace pole to the stand,
use the screw 8 M4x12 to fix it.
2 Take care not to touch the stand and
the brace pole;
3 Fix the PMMA baffle with the
screw 2
Install the PMMA Baffle
After installing the brace pole(see figure below)
baffle
and put the baffle into the stand.
rip the protective sheet off of the PMMA
Install the Stand
Face the PDP screen upside down on a clean blanket or the bracket and pay attention not to indent the casing. (See figure)
Lay down the stand and put it to responding position of the PDP screen ,and make sure the brace pole towards the hole of the PDP .
Fix 2 PDP brace pole to the PDP on the back of the plasma display with 4 M5X16 screws.
Install the Stand to the PDP
Owner s Manual 15