Filter
Top Products
Display mode
1. choose the device you wish to program.
2.To enter display mode, while press and holding ENTER
key, press the INPUT key and device LED will be ON,
keep the status for about 3 seconds and the LED will
blink, indicating that the Controller is ready for
programming, then release both keys.
3. Sequence press 9, 8, 0 to enter display mode.
4.Press digit 1 key to get the first digit of current codeset.
For example, if the first digit of codeset is 1, so then led
will blink once and remains OFF. Digit “0” in codeset
will not be displayed. Blink Freq is 1HZ.
5.Press digit 2 key to get the second digit of current
codeset. For example, if the second digit of codeset
is 3, so then led will blink three times and remains OFF.
Blink Freq is 1 HZ.
6.Press digit 3 key to get the third digit of current codeset.
Blink Freq is 1 HZ.
7. Only digit 1, 2, 3 are valid in this mode. And the
sequence is not fixed.
Controller will not send out data in this mode if user
presses any keys other than digit 1, 2, 3, or no key was
pressed in 30 seconds, display mode is ended.
Punch-Through Features
The Controller provides two punch-through features that
allow users to control TV volume and DVD or VCR
operation while the Controller is in another device mode
control certain features of another device.
Volume Punch-Through
The TV Volume/Mute punch-through feature allows you
to control the volume and mute function of your TV while
the Controller is in another device mode. The feature is
applicable for all devices and brands that do not use the
volume control buttons for other purposes.
Transport Key Punch-Through
The DVD or VCR transport key punch through feature lets
you control the PLAY, STOP, PAUSE, REWIND, FF and
RECORD functions of your DVD or VCR while the Control
operates in other modes. The feature is applicable for all
devices and brands that do not use the transport keys for
other purposes.
Fast Programming Haier default TV
codeset
Press and holding the ENTER key and then press POWER
key for 3 seconds, the LED will blink 3 times and turn off,
default Haier codeset (001) will be programmed to the
control.
Operation
Owner s Manual 35
Universal Remote Control