Filter
Top Products
Simple troubleshooting
Symptom
Factor
Solution
Snowflake speckle and
sound noise.
TV image is better, but
has noise.
TV system setting is incorrect. Enter to menu, reset sound system again ."TV"
No image. No sound.
Power plug is loose, power
cord don't connect well.
1.Check power cord whether or not connect well.
2.Check if the machine is on standby.
3.Check if the power switch button is on
TV image have stripe.
Signal is exposed to disturb,
such as car, neon light, electric
blower etc.
Don't use electric blower around machine, adjust
antenna cable direction to reduce disturb.
TV image have shadow.
1.TV signal is reflected by valley
or building.
2.Toward direction of antenna
cable is incorrect.
1.Use high directional antenna cable. Use FINE
TUNING of .
2.Adjust toward direction of antenna cable.
"TV"
No color.
1.Color saturation is too low.
2.Color system is incorrect .
1.Enter to add up color saturation.
2.Enter to change color system.
"PICTURE"
"TV"
TV no sound.
1.Volume setting is too low.
2.Sound is muted.
3.Sound system is incorrect.
1.Adjust volume to proper value.
2.Press MUTE button on remote control to
eliminate mute.
3.Enter to change sound system.
""
"TV"
1.Check the antenna cable connector plug whether
or not loose, cable whether or not perfect.
2.Refer to channel setting method, resetting again.
3.Check antenna cable type(VHF/UHF)
4.Adjust direction or position of antenna cable .
5.Attempt to use signal amplifier.
1.Antenna cable connector is
loose, cable is damaged.
2.Channel setting is incorrect.
3.Antenna cable type is not
matching.
4.Direction or position of antenna
cable is incorrect.
5.Signal is weak.
29
HAIER 19L11A / 22L11A / 23L11 ( )(6M16