Filter
Top Products
Troubleshooting
For the sake of time and cost, it is strongly recommended that you check out
the problem by yourself according to the instructions listed hereunder before
contacting the after-sales service for technical assistance.
Note: Production of the plasma screen requires high and precision technologies. However,
there might be some dark or bright (red, blue or green) spots, or some anomalistic stripes or
spots. This is not defect. If the TV set is used in an area 2,400 meters above the sea level where the air
pressure is below 750hpa, the picture on the plasma screen may be affected and a muffled sound might
be produced. These phenomena might happen in the area 1,500 meters above the sea level. This is
resulted from difference between air pressures inside and outside the display. This is not a defect covered by
the limited warranty.
NOTE: Design and specifications are subject to change without notice.
The dimension in this manual is a approximation.
Note: Do not leave the television with static picture in an extended period as it may result in
residual image on your television screen.
Horizontal/vertical bars
or picture shaking
Check for local interference such as an electrical
appliance or power tool.
No picture, no sound
Verify if the television is properly plugged.
Verify if the television is properly supplied power.
Verify if electricity is available.
Blank screen
Verify if correct signals are input.
Press TV/AV button to change signal input to TV input.
Restart the television of power supply is interrupted.
No sound
Press Mute button and verify if Mute mode is set.
Switch to other channel and verify if the same problem
happens.
Press VOL+ button to see if the problem can be solved.
Poor sound
Verify if sound system is correct. Refer to some chapter
for adjust.
No picture in some
channel
Verify if correct channel is selected.
Adjust the antenna.
Make adjustments by Fine Tune and Manual Search.
No color for some
channel program
(black and white)
Verify if the same problem exists in other channels.
Check out of picture and sound systems.
Refer to relative instructions in the Manual for color
adjust.
Spots with some or
all pictures
Verify if the antenna is correctly connected.
Verify if the antenna is in good condition.
Make fine adjustment of channel.
Television out of control
Disconnect the television from power supply and, 10
seconds later, connect the television to the power supply.
If the problem still exists, contact authorized after-sales
service for technical assistance.