Filter
Top Products
12
Limited Warranty
This REMOTE CONTROL SYSTEM is warranted for
12 months from the date of purchase or installation to
the original purchaser to be free from defects in mate-
rials and workmanship. Damage to the SYSTEM
caused by accident, misuse, abuse, or installation
error whether performed by a contractor, service com-
pany, or owner, is not covered by this warranty. Seller
will not be responsible for labor charges and/or dam-
age incurred in installation, repair, replacement or for
incidental or consequential damages. Batteries and
any damage caused by them are not covered by this
warranty.
Some states, provinces, and nations do not allow
exclusion or limitations of incidental or consequen-
tial damages, so the above limitations or exclusions
may not apply. This warranty gives you specific legal
rights. You may have other rights that vary by state,
province or nation.
Service Parts
No service parts available.
• Cause the RF signal to get lost and not communi-
cate with the receiver.
• Cause the working distance to be shorter than nor-
mal.
NOTE: A receiver located in an area, where the ambient
temperature inside the case exceeds 130
0
F, will cause
the THERMO-SAFETY feature to cut in, requiring you to
reposition the receiver to stop the warning beeps, and to
“reset” the receiver’s operation.
Specifications
Batteries: Transmitter - 3V 2 ea.; AAA 1.5V, Alkaline
Receiver: (4) AA I-SV Alkaline
Operating Frequency:
FCC ID No.’s:Transmitter - ULERF-5A
Receiver - ULERF-5A
Canadian IC ID No.’s:
Transmitter - 6732A-RF5A
Receiver - 6732A-RF5A
Troubleshooting
To check the operation of the remote:
1. Make sure receiver batteries are installed properly. If one
battery is installed backward, receiver will not operate in
remote mode. Be sure battery output is 5.3 volts or more.
(Slide switch is independent of battery condition).
2. Be sure the transmitter’s batteries are properly installed
and that the battery output is 2.7V or more.
3. Check to make sure the transmitter is communicating
with the receiver.
• If the receiver beeps when the MODE button is de-
pressed on the transmitter they are communicating.
• If the receiver does not beep when the MODE button
is depressed on the transmitter go to Matching Secu-
rity Codes.
4. Make sure the transmitter is within the 20 feet range of
the receiver.
5. Positioning of the receiver is important. If the receiver is
“enclosed” in a metal surround, the operation of the re-
ceiver may be affected as noted below. Reposition the
receiver to improve operating range. It is suggested that
a heat shield be installed to protect the receiver from
extreme heat. If the receiver is “enclosed” in a metal
surround, this can:
433.92MHZ