Filter
Top Products
To enjoy the programs coming from your audiovisual equipment such as VCR, DVD, Satellite receiver, Camcorder,
Audio amplifier etc, the signal must be received by the set via the AV input terminals at rear. Connect the devices as
the shown below.
Note: When connecting YUV (Y Cb Cr) jacks, Audio Left and Right cables should be connected to AUDIO
INPUT terminals.
Connecting the audiovisual equipment
Connecting your TV
To enjoy the signal transmitted by your local TV station, you need an indoor or outdoor antenna ( not supplied ).
Perfect picture quality requires a good signal and generally means that an outdoor antenna must be implemented.
The exact type and location of the antenna will depend on your particular area. Consult your local dealer or service
personnel for best advice. If you are a subscriber of your local CATV net, the outdoor or indoor antenna is not needed.
Connect the equipments as the following figure.
-6-
Connecting the antenna
Antenna Socket
Rear View
IN
S-VIDEO
VIDEO
AUDIO
MONO
Y
Cb
Cr
ANT75
OUTPUT
VIDEO
LEFT(MONO)
RIGHT
To the input terminals
PLAY VIDEO TAPE, DVD etc.
TV
OUTPUT
Y
Cb
Cr
VCR/DVD
VCR/DVD
Loosen the screw
Insert the feeder in
Tighten the screw
Plug(not supplied)
Adaptor (not supplied)
The signal comes from:
An outdoor antenna
An indoor antenna
CATV net
Twin-Lead Feeder(300 W )
Coaxial Cable (75W )
IN
S-VIDEO
VIDEO
AUDIO
MONO
Y
Cb
Cr