Hitachi 32LD9700U Flat Panel Television User Manual


 
71
ENGLISH
TROUBLESHOOTING (continued)
Symptom and Check List (continued)
Symptoms Check list Page
No picture
The Indicating lamp Off
Check if the Power Cord is plugged into the socket rmly.
Check if the Main Power is ON.
19
,
20
No picture
The Indicating lamp Orange
It means that the unit is in “Power Save
mode”.
Check if all the cables of the external equipments are connected
correctly and rmly.
Check if the power of the external equipments is ON.
Check if the TV/AV mode has been selected correctly.
Check if the PC is in Power Save mode or not.
Refer to “Power Save mode” and “When following messages appears on
the screen”.
68
No picture
The indicating lamp Green
Check if the signal cable is connected correctly and rmly.
Adjust the level of Brightness, Contrast and Back Light lower.
15
~
18
The top of the unit and surface of the
panel heat up.
It may happen when you use the unit for long hours. Turn off the Main
Power of the unit for a while. Please note that this is not malfunction.
73
,
75
Image cannot be displayed in the correct
position.
Press
button to check if the input signal of the displayed image is
compatible with the speci cation of the television.
28
,
73
,
75
When the VCR is in special playback
features (Fast Forward or Rewind), the
screen gets dark and cannot see the
image at all.
It could happen when the VCR is connected to Component output, such
as 480i. This is not malfunction.
Try Composite output or S-video output and check the picture again.
The images are not displayed on sub
pictures in “Multi Picture mode”
There are some combinations of input signals that the images are not
displayed on sub pictures.
Please check the Table of “2-Picture” and “4-picture/2-picture(1080i)” for
details.
57
~
59
76
Screen display size cannot be switched
correctly.
The display size is xed at “FULL” when the receiving signals are
1080i/60Hz, 1080i/50Hz, 720p/60Hz, or 720p/50Hz.
Check the signal status by pressing the
button on the remote
control.
52
~
53
Cannot be displayed the image from
HDMI 1 or 2.
Check if the cables are connected correctly.
Check the output format of the equipments.
(Please refer to “Connecting Procedure” and “Recommended Signal
List”.)
73
~
75