Filter
Top Products
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
53
1. If your television set is to remain unused for a long period of time, for instance, when you
go on a vacation, unplug the television set from the wall outlet.
2. Do not subject the Remote transmitter to shocks such as dropping it on the floor, etc.
Precision parts may be damaged.
3. Do not allow the Remote transmitter to become wet and avoid placing it in areas of high
humidity. Don't leave it on or near a heater. Excess heat or moisture may cause the unit to
cease operation.
4. If the batteries become exhausted, Remote control operation may become erratic or stop
altogether. Replace the old batteries with two fresh "AA" (SUM-3) types.
NOTES
1. When the power button is set to OFF, the OFF TIMER is released.
2. The channel No. indication, volume indication and OFF TIMER indication are not
displayed simultaneously.
3. To operate your TV, point the Remote transmitter at the remote sensor of the TV.
NOTES
1. To operate your TV, be sure to point the Genius Remote at the remote sensor on the
television. To operate other electronic equipment like a VCR, point the remote at the
remote sensor on the device.
2. Refer to the instruction manual of the VCR for operation of the buttons exclusively for the
VCR.
3. Be sure to keep the original remote transmitter even after storing its codes in the Genius
Remote Control
If the Genius Remote is left with its batteries removed, the learned codes in its memory are
erased and will have to be reprogrammed into the memory.
4. The Genius Remote Control may not be abel to learn certain special remote codes.
Caution on batteries
• The Genius Remote Control is working when the LEARN indicator lights up when a button
is pressed.
• When you press a button and the LEARN indicator will not light up or if the operation is
extremely slow, this is an indication that the batteries should be replaced.
• Even if the batteries seem dead, do not remove them until you have replacement batteries
ready to put in. The codes stored in memory will be erased in a few minutes without power.
When replaceing batteries prepare the new ones first.