Filter
Top Products
-8-
Before Switching On Your TV
Power Connection
IMPORTANT: The TV set is designed to op-
erate on 220-240 V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The Aerial Input
Socket
VHF/UHF
75
:
REAR OFTHE TV
CABLETV
• Connect the aerial or cable TV plug to the
Aerial input socket l ocated at the rear of the
TV and connect the cable plug coming out
from t he TV out socket loc ated on the de-
vices (VCR, DVB etc.) to this socket as well.
How To Connect Other Dev ices
IMPORTANT: Switch off the TV before con-
necting any ex ternal device.
Sockets for external connections are at the
rear side of the TV. For c onnection of other
devices via S cart refer to the manuals of the
related devices.
Inserting Batteries In T he Remote
Control Handset
• Remove the battery cover located on the
back of the handset by gently pulling down-
wards from the indicated part.
• Insert tw o AA/R6 or equivalent type batteries
inside. Place the batteries in the right direc-
tions.
• Replace the battery cove r.
NOTE: Remove the batteries from remote
control handset when it is not to be used for
a long period.Otherwise it can be damaged
due to any leakage of batteries.
Switching The TV ON/OFF
To switch the TV on:
Your TV will switch on in two steps:
1- Connect the power supply cord t o the sys-
tem. Press On/Off switch “
” at the bottom
right side of the TV. Then the TV switches it-
self to stand-by mode and the led on the
front of the TV becomes Red.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press the "
"or" " button at the bottom of
the TV or press the “P-” or “P+” button on
the remote control, so that last mode
switched off is selected.
By eit her method the T V will sw itch on and
the led becomes green.
T o switch the TV off:
•Pressthe“ (stand-by)” button on the re-
motecontrol,sotheTVwillswitchtostand-
by mode and the GREEN LED will become
RED.
To power down the TV complet el y, press
On/Off switch “
”,
or,
Unplug the power cord from the mains
socket.
Downloaded From TV-Manual.com Manuals