Filter
Top Products
59
Lamp Replacement
6. If the lamp cover is not installed, be sure to install the lamp cover by re-engaging the two clips and tighten
the screws before turning the power on, otherwise it may cause unusual colors.
NOTE: If power is connected before the Lamp Cover is installed, the power will be off and the Lamp Indicator
will flash (see page 9).
7. Install the front cover as shown below. Put the front cover back in and align the snap on quick connect
then push inwards holding the left and right side of the front cover until you hear a snap. Push the other
snap on gently to make a good fit.
8. Plug power cord into AC outlet and turn on the main power switch.
NOTE: This product contains lead and a lamp that contains mercury. Dispose of this product and its lamp
in accordance with applicable environmental laws. For lamp recycling and disposal information, go to
www.lamprecycle.org. For product recycling and disposal information, contact your local government
agency or eRecycle.org (in California), the Electronic Industries Alliance at www.eiae.org (in the US) or
Electronic Product Stewardship Canada atwww.epsc.ca (in Canada).
For more information, call “1-800-Hitachi”.
Lamp Replacement
120V
SCREW
LAMP COVER
PHILLIP HEAD
SCREW DRIVER
Hg