Hitachi 53F300 Projection Television User Manual


 
28
THE REMOTE CONTROL
Operating the precoded function for your cable/satellite box.
This remote is designed to operate different types of cable/satellite boxes.You must first program the remote to match the remote sys-
tem of your cable/satellite box (refer to table below for pre-codes).
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. Press and release the cable/satellite (CBL/SAT) button to switch to cable/satellite pre-coded mode.
4. Hold down the CBL/SAT button on the remote and enter the two digit preset code that matches your cable/satellite box as shown
below.
5. Aim the remote at the cable/satellite box and press the POWER button. The remote will turn off your cable/satellite box when the
correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable/satellite box. If the box
does not turn off, try a different two digit preset code.
6. The remote will now control your cable/satellite box.
NOTES:
1. If your cable/satellite box cannot be operated after
performing the above procedures, your cable/satellite box
code has not been precoded into the remote.
2. In the unlikely event that your cable/satellite box cannot
be operated after performing the above procedures,
please consult your cable/satellite box operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
CABLE (CBL/SAT) button
This button allows the remote to control your cable/satellite
box by setting it to CABLE/SATELLITE mode.
PRECODED CABLE/SATELLITE BOX buttons
These buttons transmit the chosen precoded cable/satellite
codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
123
456
789
0
ANT
INFO
VOL CH