Filter
Top Products
SETUP
66
Use this feature to give a name to any of the five video inputs.
Press THUMB STICK ̆, ̄, ̇, ̈, to highlight the name of the video inputs.
Press down on THUMB STICK to select desired input name.
Select RESET to set video names to original factory preset condition.
Set The Inputs
THUMB
STICK
SELECT
Setup
Move
SEL
Return
Set The Inputs
Video1 Rename
Video2 Rename
Video2 Auto Link
Video3 Rename
Video4 Rename
Video5 Rename
IEEE-1394
Set The Channels
Set The Clock
Menu Preference
Setup
Set The Inputs
Move
SEL
Select
Set Event Timer
Set Closed Captions
MENU
THUMB
STICK
THUMB
STICK
Setup
Move
SEL
Select
Set The Inputs
Setup
Move
SEL
Return
Set The Inputs
List
CAM DVD2 VCR
CBL LD VCR1
DVD SAT VCR2
DVD1 STB Reset
THUMB
STICK
SELECT
Video1 Rename
Video2 Rename
Video2 Auto Link
Video3 Rename
Video4 Rename
Video5 Rename
IEEE-1394
About Your TV
Video 1 Rename
Set Monitor Out
Upgrades
NOTES: 1. Auto Channel Scan must be performed first when using ANT C for the first time.
2. When in ANT C, only channels stored in Channel Manager during Auto Channel Scan can be tuned using the
number buttons on the remote control (see pages 54-55, and 65).
3. When Source-Cable is selected, performing Auto Channel Scan in ANT C will also store scrambled channels in its
memory. These channels will be shown as blank on the screen when the channel selector buttons on the remote
control are used. Please use CHANNEL MANAGER menu to skip (Scan - Off) these scrambled channels
(see page 54).
4. Turning the power off while executing Auto Channel Scan will only store channels scanned before the power
interruption.
5. If your ANT C source is an antenna, repeat Auto Channel Scan everytime antenna position/direction is changed.
6. Channel availability in ANT C depends on the broadcaster. Certain channels that are available during the day may
not be available at night.