Filter
Top Products
HARDWARE OPTION
• Audio connecting cable
• Sound card
SOFTWARE
• DVD-ROM device driver
NOTE: If you need an interface card, interface cable or DVD-ROM device
driver, contact your dealer.
To install this DVD-ROM drive in the host computer, refer to the instruction
manual of each host computer. To install the interface card in the host
computer, refer to the instruction manual of each host computer and each
interface card.
Install the DVD-ROM drive following the general installation procedure shown
below:
1) Check the Device Configuration Jumper Settings of the DVD-ROM drive
such as Master, Slave, CSEL. (See page 9)
2) Turn off the host computer and unplug the power supply cable of the host
computer.
3) Remove the host computer cover.
4) Install the DVD-ROM drive into the host computer and mount tightly
with screws.
5) Check the settings of the interface card.
6) Install the interface card in the slot.
7) Firmly attach the interface cable from the interface card to the DVD-ROM
drive.
8) Firmly attach audio connecting cable as required.
9) Finally, firmly attach a spare DC power supply cable from the computer
power supply to the DVD-ROM drive.
10) Install the host computer cover.
GD-2000 DVD-ROM Manual - Page
Hardware Installation
GD-2000 Manual 6/18/98 5:25 PM Page 10