Filter
Top Products
12
Quick Setup Guide
a). Secure it with the Wire Clamp (see page 7) .
Wire Clamp
b). Connect the power cord to the AC outlet.
c). The Indicating Lamp will light red (Standby mode) and then
light blue (picture is shown).
2. CONNECT YOUR NEW HITACHI LCD TV TO THE POWER SOURCE
3. POWER ON/OFF YOUR NEW HITACHI LCD TV
Press the POWER button on the remote control or the POWER
button on the Front Control Panel to power on/off the LCD TV.
or
Air/Cable
Rear Panel Jack
CLU-49101S
For Stand-By
Power OFF
If the Indicating lamp is off, the POWER button on
the remote control will not operate. Please make sure
that the power cord is plugged to the AC outlet.
NOTE
4. FOLLOW THE TV SETUP WIZARD INSTRUCTIONS ON NEXT PAGE
Indicating
Lamp
Perform the following steps to quickly setup your new
Hitachi LCD Television Set.
1. ANTENNA CONNECTION
Unless your LCD Television is connected to a cable TV system or
to a centralized antenna system, a good outdoor color TV antenna
is recommended for best performance. However, if you are located
in an exceptionally good signal area that is free from interference
and multiple image ghosts, an indoor antenna may be sufcient.
VHF (75-Ohm) antenna/CATV (Cable TV)
When using a 75-Ohm coaxial cable system, connect the CATV coaxial
cable to the AIR/CABLE (75-Ohm) terminal. Or if you have an antenna,
connect the coaxial cable to the same AIR/CABLE terminal.
To outdoor Antenna
or
Cable TV (CATV)
System
To AIR/CABLE
Terminal