Filter
Top Products
8
How To Install Your New Hitachi Plasma Television
WALL MOUNTING SETUP
STEP (1) : REMOVE THE TABLE TOP STAND FROM THE PLASMA TELEVISION
Please remove the 4 screws shown below in order to separate the TV from the Table Top Stand. Now the Table Top Stand can be
separated from the TV. Useful dimensions for the WALL MOUNT assembly are in page 47.
Although this Plasma Display Panel can be installed using a variety of third party wall mounting
•
brackets/devices, such third party brackets/devices have not been tested or approved by Hitachi for use or
compatibility with this Plasma Display Panel. Accordingly, Hitachi accepts no responsability or liability for
any injuries or property damage resulting from the use of such third party brackets/devices. Hitachi strongly
advices that any installation of this Plasma Display Panel using wall mounting brackets/devices be performed only by a qualied and
experienced television installation technician who has completed a thorough evaluation of:
a) the weight-bearing strength and stability of the intended wall mount surface; and
b) the weight-bearing strength and compatibility of the intended wall mount brackets/device.
CAUTION
4 SCREWS
TABLE TOP STAND
STEP (3) : TIPS TO CONSIDER FOR THE LOCATION OF THE PLASMA TELEVISION.
Screw Mounting Holes (4 places). Don't
use the original screws (A) that comes in
the TV for the Wall Mount Bracket. The
length is not long enough.
Wall Mount Brackets
Screw Length (A)
Insertion length (B)
Spring Washer (C)
Plane Washer (D)
Wall Mount Bracket (E)
Example :
A = B+C+D+E
A: 13~15 mm.
B: 9~11 mm.
C: 1 mm.
D: 1 mm.
E: 2 mm.
The screw type :Theread ISO M6 (Metric
type, do not use Standard type).
For Wall Mount assembly; please refer to the Installation Manual of the
Wall Mount Unit.
Insertion length (B) of the screws must be within 9~11 mm. If the length is less than 9 mm, the
weight can not be maintained. If the length is more than 11 mm, a space is created between
the Wall Mount Bracket and the Plasma Television. This length is very important.
STEP (2) : INSTALL THE WALL MOUNT BRACKETS ON THE PLASMA TELEVISION USING 4 SCREWS.
More than
30 cm (1').
More than
10 cm (4").
Keep
more than
2 cm (0.8")
away from
the wall.
Do not block the ventilation holes. In •
addition please keep a certain distance around
and make sure not to obstruct ventilation.
Blocking the ventilation holes might cause re or
defect.
If you purchased the Wall Mount unit, please ask for a professional •
installer. Do not install by yourself.
This plasma unit features an advanced ventilation system configured •
for vertical installation. A knowledgeable and experienced professional
technician can perform other mounting or installation orientations (e.g.,
horizontal, tilted) provided that you specically inform the technician of
the unit's specialized ventilation needs. Call 800-HITACHI for additional
info and guidance.
CAUTION
CAUTION