Filter
Top Products
Basic Operations
30
Press DISPLAY a fourth time to end the on-screen display.
The linear time counter operates only if there is something recorded on the tape.
The counter changes to 0:00:00 when the tape is ejected.
Marking with the Time Counter
If there is one part of the video that you know you are going to want to return to, you can
set the time counter to memorize that spot. Begin in either STOP or PLAY mode.
Press DISPLAY twice to show the counter on the TV screen.
Begin recording or playing back a tape. Notice the counter remains on the screen.
At the point that you want to go back to, press CLEAR. This resets the counter to
0:00:00.
Press STOP when you are done recording or playing back the tape.
Press DISPLAY again and an "M" will display below the counter on the TV screen:
This indicates that the counter's memory function is engaged.
Now when you rewind the tape, it will automatically stop at the spot where you cleared
the counter. (Notice it moves just past the marker and then back to it.) Press PLAY to
watch the tape from that preselected spot.
Press DISPLAY to take the counter display off. The spot is still in memory until you
set a new one or until the tape is ejected.
Jump Forward or Backward with GO-TO
Using the time counter, you can search for a spot a certain number of minutes before or
after your current position on the tape.
Press STOP, if tape is playing, and press DISPLAY, then press 8 button to bring up the
Set Go-To Time screen:
Select minutes by pressing buttons 0 to 9-one digit for hours, then two digits for
minutes. If you enter a wrong digit, press CLEAR and enter the correct one. Then press
F.FWD if you want to move that many minutes ahead, or REW if you want to move that
many minutes backward.
For example, say you want to review a scene that began about 2 minutes earlier in a
video, press 0,0 and 2 to display 0:02 on the screen. Then press REW.
The tape rewinds to the place 2 minutes back from where you began, then starts
playback automatically from that spot.
Jump to an Index Mark with INDEX
A quick way to access specific program segments is with the index search feature. This
lets you move through a tape that has several recordings on it by searching for the