Hitachi VTMX-231A VCR User Manual


 
TIMER RECORDING
35
CHANNEL 16
REC SPEED - -
• Remember refer to "ANTENNA/CABLE CONNECTIONS" on pages 11 and 12 if you have a cable box or satellite
box before setting the channel number.
10 Set the tape speed
Press /PLAY or /STOP button repeatedly until your desired tape speed appears. (Example: SP)
ONE TIME PROGRAM
DATE 05 / 06 WED
START TIME 07 : 30 PM
END TIME 08 : 30 PM
CHANNEL 16
REC SPEED SP
SP LP
SLP
11 Finish setting the program
Press F.FWD/ button. Program 1 is now completed.
• To set another program, repeat steps [2] to [11].
• Press RESET/EXIT button to return to original mode.
12 Set the timer
Press POWER button. The "þ" indicator appears on the VCR's digital display.
• Please see "HINTS FOR TIMER RECORDING" on page 24 for more information.
HINTS FOR TIMER RECORDING
• If there is a power failure or the VCR is unplugged for more than 30 seconds, the clock setting and all timer settings are
lost.
• If the tape runs out before the end time, the VCR will switch to the Stop mode immediately, eject the tape and the VCR
power will be turned off. The "þ" indicator will flash.
• If a tape is not inserted or the erase-protection tab is removed, the "þ" indicator flashes and timer recording cannot occur.
Please insert a recordable tape.
• The TV that is connected to your VCR may be turned ON or OFF when the VCR is in the timer-record mode.
CORRECTING AN AUTOMATIC TIMER PROGRAM
1) Turn the power on.
2) Repeat steps [1] to [3] on page 22.
3) Go to the digit you want to change using the F.FWD/
button or REW/ button.
4) Enter correct numbers using
/PLAY or /STOP button.
4) Press RESET/EXIT button to return to original mode.
5) Press the POWER button to return to timer stand-by mode.
STOPPING A STARTED AN AUTOMATIC TIMER PROGRAM