Filter
Top Products
Adapter Kit Installation – Kit 46-00911
1. Remove the rubber feet on the bottom of the 7580.
2. Attach the adapter plate to the bottom of the unit with the four
M3 x .5 x 10 mm screws ( ) provided in the kit.
3. Attach the base plate to the adapter plate with the four M3 x .5 x 8 mm
screws ( ) provided in the kit.
Figure 3
4. Before mounting the locking plate, consider the position the unit will rest
when fully installed. There are two tabs located on the locking plate.
These tabs indicate the two directions the unit may face when locked into
position (see figure below).
Figure 4
- 2 -