Humax PVR-8100T DVR User Manual


 
**
16.1 Trouble Shooting
Before contacting your local service, please make sure following instructions. If the product does not
work normally after completing the following trouble shooting, please contact your local product
distributor or service centre.
1. No message is displayed on the front panel or product has no power.
- Check the main power cable and check that it is plugged into a suitable power outlet.
- Check whether the Power Switch is On.
2. No picture
- Make sure that the product is in Operation Mode.
- Make sure that the AV Cable is firmly connected to the TV.
- Make sure that Aerial line is correctly connected to the equipment.
- Check the brightness level of TV.
- Check the channel is on air.
3. Poor picture & sound quality
- Install the aerial in a place where there is no obstacle.
- Make sure there is no mobile phone or microwave oven near the equipment.
- Use 75
coaxial cable to connecting TV and aerial.
4. No or poor sound
- Check the volume level of the TV and Receiver.
- Check the Mute status of the TV and product.
- Press the Audio button to change the Sound Track type.
5. Remote control does not operate
- To control the equipment with the remote controller, the remote controller's top end should
directly point towards the receiving part of receiver's remote controller.
- Check the battery of Remote controller.
6. Reservation is not available.
- Check whether it it not overlapped with other reservation.
- Check whether the power switch is off.
**
16. Trouble Shooting
GB 80
**
**
**
**
**
**
**
**
**
**
**
**
**
**