Filter
Top Products
SETTING UP YOUR BIG BUTTON™
INSTALLING THE BATTERIES
Your BIG BUTTON™ requires 2 fresh AA-size batteries (alkaline batteries recommended).
1. Remove the battery cover on the back of your BIG BUTTON™.
2. Observe the polarity of the batteries and the “+/-” marks inside the battery compartment.
3. Insert the batteries.
4. Push the battery cover back in place.
Note: When all batteries are disconnected, the BIG BUTTON™ retains it’s settings for a
few hours. Should you fail to replace the batteries in time, you may have to reprogram.
See SETTING UP YOUR BIG BUTTON™ Section.
There are 5 Device Modes (TV, VCR, CBL/SAT, DVD and TIVO) in your BIG BUTTON™.
You may setup the BIG BUTTON™ by using device codes or by using power scan
(searching) instructions.
Important- If you are programming a TV/VCR Combo, try VCR codes first!
Program TIVO by using the DVD button and then entering codes.
USING DEVICE CODES
At-A-Glance:
MODE (3 sec) → digit→ digit→ digit
(e.g. for a Zenith TV, press and hold
"TV" button until LED starts blinking,
then press and release "0", "6", "9")
1. Referring to the DEVICE CODE LIST, look up the 3-digit Code Number that corre
sponds to the brand and models of your equipment. If there is more than one DEVICE
CODE listed under your brand, try the first code with the following instructions:
2. Hold down the Device Mode Button (e.g. TV) until the status LED indicator (located
above the "ON/OFF" button) begins to blink. (This takes about 3 seconds) Then
release the button.
3. Enter the three digit code of the DEVICE from step “l” above. Upon entry of the third
digit, the status indicator will blink a confirmation (3 blinks) if the code was accepted,
but will turn OFF immediately if the code was rejected. If rejected, try another code.
4. Try the functions on the BIG BUTTON™. If your device responds to your requested
function correctly, you have entered the correct Code. Otherwise, repeat the above
setup instructions with the remaining Device Codes until your device (e.g. TV)
responds to your requested function. Simply repeat the above procedures to enter the
Device Codes for your VCR, CBL/SAT, DVD or TIVO
(Remember to press Device Mode Button TV, VCR, CBL/SAT or DVD in step 2
above).
NOTES:
• If you cannot find a correct Device Code for your equipment, see USING POWER
SCAN (searching) section .
• It is highly recommended, to write down your Codes on the bottom label of your BIG
BUTTON™.
USING POWER SCAN (SEARCHING)
At-A-Glance:
MODE (3 sec) → ON/OFF → ARROW UP (▲) or ARROW DOWN (▼) → ENTER
2