Filter
Top Products
To set the console mode to Operations Console at DST, do the following
starting at the DST main menu:
a. Select Work with DST environment.
b. Select System devices.
c. Select Console mode.
d. Depending on your Operations Console configuration, select either
Operations Console (LAN) or Operations Console (Direct).
e. Exit Dedicated Service Tools.
A normal IPL after this process should clear SRC A900 2000.
__ 2. If you want to start device parity on any non-configured units, do it now.
For more information, see the manual Backup and Recovery, SC41-5304-05.A
PDF version of this manual is available from the Information Center under
Systems Management -> Backup, recovery, and availability -> Manuals
and Redbooks.
__ 3. Perform disk unit management (for example, manage disk protection and
disk configuration). To do this, you can use the Work with Disk Units option
from the Dedicated Service Tools display. For more information, see the
manual Backup and Recovery, SC41-5304-05. A PDF version of this manual is
available from the Information Center under Systems Management ->
Backup, recovery, and availability -> Manuals and Redbooks.
__ 4. Save the entire system just after the hardware upgrade is done. Use option
21 on the Save menu. For more information about saving the entire system
using option 21, refer to any of the following:
v The chapter on saving your iSeries server in the manual Backup and
Recovery, SC41-5304-05. A PDF version of this manual is available from the
Information Center under Systems Management -> Backup, recovery,
and availability -> Manuals and Redbooks.
v The Backup, recovery, and availability topic under Systems
Management in the Information Center:
http://www.ibm.com/eserver/iseries/infocenter
To find the procedure for saving the entire system (using option 21) in the
Information Center, do the following:
a. Click Systems Management
b. Click Backup, recovery, and availability
c. Click Backing up your server
d. Click Saving your server with the GO SAVE command
e. Click Saving your whole server with GO SAVE: Option 21
__ 5. Generate reports of the hardware and configuration objects (for each
partition) by issuing the following commands:
DSPHDWRSC TYPE(*LWS) OUTPUT(*PRINT)
DSPHDWRSC TYPE(*STG) OUTPUT(*PRINT)
DSPHDWRSC TYPE(*CMN) OUTPUT(*PRINT)
DSPHDWRSC TYPE(*PRC) OUTPUT(*PRINT)
DSPPTF LICPGM(*ALL) OUTPUT(*PRINT)
__ 6. Print a new system configuration list using Start a service tool option.
a. Do the following on the OS/400 Main menu command line:
Type Start System Service Tools (STRSST).
Press the Enter key.
Chapter 3. Procedure for an Upgrade (RISC-to-RISC) 29