Insignia NS-LCD26-09 Flat Panel Television User Manual


 
4
Insignia NS-LCD26-09 26" LCDTV
www.insignia-products.com
Note to CATV system installer
This reminder is provided to call the CATV
system installer’s attention to Article 820-40 of
the NEC that provides guidelines for correct
grounding and in particular, specifies that the
cable ground must be connected to the
grounding system of the building as close to the
point of cable entry as practical.
Mobile telephone warning
To avoid interference with your TV picture and
sound, operating problems, or even damage,
keep your cordless and cellular telephones away
from the TV.
Non-active pixels
The LCD panel contains almost 3 million thin film
transistors, which provide exceptionally sharp
video quality. Occasionally, a few nonactive
pixels may appear on the screen as a fixed blue,
green, or red point. These non-active pixels do
not adversely affect the performance of your TV,
and are not considered defects.
Features
Front
Remote control
6 Grounding clamp
7 Antenna lead-in wire
# Button Description
1 VOL+ Press to increase the volume. In Menu
mode, functions as the right arrow to
go to the next menu or increase a
setting.
2 VOL– Press to decrease the volume. In Menu
mode, functions as the left arrow to go
to a previous menu or decrease a
setting.
3
CH
Press to go to the next higher channel.
In Menu mode, functions as the up
arrow.
4
CH
Press to go to the next lower channel.
In Menu mode, functions as the down
arrow.
5 MENU Press to show the on-screen menu.
6 INPUT Press to cycle through the available
input sources. In Menu mode,
functions as the ENTER button.
7 POWER Press to turn on your TV or put it into
Standby mode.
1
2
3
5
6
4
7
# Button Description
1
POWER
Press to turn on your TV or put it
into Standby mode.
2 INPUT Press to select the video input
signal source.
3 DISPLAY Press to display status
information.
4 VIDEO Press to toggle between S-Video
and composite source modes.
5 Number buttons Press to enter channel numbers. In
the on-screen menu, press to enter
your parental control password.
6 Use with the 0-9 number buttons
and ENTER button to select digital
channels.
7 VOL + Press to increase the volume.
8 MUTE Press to mute the sound. Press
again to restore the sound.
9 VOL – Press to decrease the volume.
10 MENU Press to open the on-screen menu.
11 Press to move down, up, left, or
right in the on-screen menu.
12 ENTER Press to confirm changes or to
turn options on and off in the
on-screen menu.
13 P.LOCK Press to activate or deactivate
parental controls. See “Setting
parental controls” on page 9 for
information on setting up parental
controls.
INPUT
VIDEO COMP
MUTE
FAVORITE
MENU
P-LOCK MTS/SAP CCD
ZOOM
PICTURE AUDIO
SLEEP
FREEZE
EXIT
TV
DISPLAY
POWER
123
456
0
ENTER
RECALL
VOL
VOL
CH
CH
HDMI
789
ZRC-101
1
2
3
5
6
7
8
4
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28