Filter
Top Products
17
SN 29343266 DPC-5.2
Connecting the Power
The DPC-5.2 is shipped with the main power (Power) switch in the on
position (_ On). When the power cord is plugged in for the first time,
the DPC-5.2 will automatically enter the standby mode and the Standby
indicator will light (same condition after step 2 below).
Turning on
2 Press Power to switch on
the main power.
The DVD Changer enters standby mode.
The Standby indicator lights up.
Notes
• The buttons on the remote controller do not operate if the
Power switch is set to Off.
• To switch off the main power, press Power again.
Notes
• Make sure that all appropriate connections have been completed
as described on pages 14 to 16.
• Turning on the DVD Changer may cause a momentary power
surge, which might interfere with other electrical equipment such
as computers. To prevent interference, use a wall outlet on a
different circuit.
STANDBY/ON
Power Standby/On
Standby indicator
1 Plug the supplied power
cord into the AC INLET
and then into the power
outlet on the wall.
Notes
• Do not use a power cord other than the one supplied with
the DPC-5.2. The power cord supplied is designed for use
with the DPC-5.2 and should not be used with any other
device.
• Never have the power cord disconnected from the DPC-
5.2 while the other end is plugged into the wall outlet.
Doing so may cause an electric shock. Always connect by
plugging into the wall outlet last and disconnect by
unplugging from the wall outlet first.
3 Press Standby/On on
the DVD Changer or
remote controller.
The DVD Changer turns on and the Standby indicator turns
off. It takes several seconds to read the disc in the disc tray.
Notes
• You can turn on the DVD Changer by pressing Open/
Close or Play.
•
To put the DVD Changer in the standby mode, press Standby/
On on the DVD Changer or remote controller. Be sure to set the
volume to minimum before putting the DVD Changer in the standby
mode for the next use to avoid sudden loud sound reproduction.
•
While the Standby indicator lights up, the DVD Changer can
receive signals from the remote controller. However, if you press
Power on the DVD Changer to switch off the main power, the
remote controller cannot be used to turn on the DVD Changer.
• Setting the Standby button to standby does not shut off
the power completely.
AC
INLET
To a wall outlet
Power cord (supplied)