Filter
Top Products
M-4109/1104 IP510, EP510, IP511, EP511 SERIES
A
10
510 and 511 Series I/P AND E/P TRANSDUCER SPECIFICATIONS
Accuracy:
± 0.10% of output span, typical
± 0.25% of output span, maximum
Hysteresis:
0.01% of output span, typical
0.10% of output span, maximum
Dead Band: Not measurable
Repeatability:
0.01% of output span, typical
0.10% of output span, maximum
Ambient Temperature Effect
Zero:
Span:
± 0.004% of nominal span per ˚F, typical
± 0.022% of nominal span per ˚F, maximum
± 0.013% of calibrated span per ˚F, typical
± 0.022% of calibrated span per ˚F, maximum
Compensated Temperature Range: +32˚F to +122˚F
Operating Temperature Range
Buna-N elastomers:
Viton elastomers:
-20˚F to 160˚F
0˚F to 160˚F
Storage Temperature Range
Buna-N elastomers:
Viton elastomers:
-40˚F to 200˚F
-15˚F to 200˚F
Vibration Effect:
Less than 0.5% of SPAN per 1G,
5-2000 Hz, 3G maximum, 3 axes
Mounting Position Effect: Not measurable
Loop Load, I/P transducer:
Less than 10 VDC drop at 20 mA
Less than 12 VDC drop at 50 mA
Supply Voltage, E/P Transducer
Intrinsically Safe/Nonincendive:
General Purpose:
9 VDC to 28 VDC, less than 20 mA
9 VDC to 40 VDC, less than 20 mA
Supply Voltage Effect: Not measurable
Signal Impedance, E/P Transducer: 6000 Ohm minimum
RFI/EMI Effect (NEMA 4X): Less than 0.25% of SPAN, 10V/meter, 20-1000 MHz.
Supply Pressure Requirements: See TABLE 1
Supply Pressure Effect: Not measurable
Air Consumption: 6.0 SCFH maximum
Forward Flow Capacity (Supply):
Standard Range 7 SCFM
Extended Range (over 30 PSI) 12 SCFM
Port Sizes:
Pneumatic: 1/4" NPT
Electrical: 1/2" NPT