Jensen DVDB01 DVD Player User Manual


 
20
DVDB01
TROUBLESHOOTING
Care and Maintenance
Use only a clean silicone cloth and neutral detergent to clean the front panel or monitor. A
rough cloth and non-neutral detergent (such as alcohol) may result in scratching or
discoloration.
Do not get water or cleaning fluids on the unit.
If the temperature inside the player gets too hot, a protective circuit automatically stops play
of the disc. If this occurs, allow the unit to cool before operating the player again.
Never insert anything other than a 5” (12 cm) compact disc into the player as the mechanism
can be damaged by foreign objects.
Do not attempt to use a 3” (8 cm) CD-Single disc in this unit, either with or without an adaptor,
as damage to the player and/or disc may occur. Such damage is not covered by the Warranty
on this product.
The ventilation should not be impeded by covering the ventilation openings with items such
as newspapers, table-cloths, curtains, etc.
The DVD player may not operate properly in extreme hot or cold. If such conditions occur,
allow the interior of the vehicle to reach a normal temperature before using player.
When the vehicle warms up during cold weather or under damp conditions, condensation
may appear on the LCD panel. Should this occur, the screen will not operate properly until the
moisture has evaporated.
We suggest you use a cleaning disc in this unit more frequently than in the unit in your home
due to the environmental conditions of the vehicle.
Problem Cause Corrective Action
Unit will not power on Radio Fuse blown Install new fuse with correct rating
Car battery fuse blown Install new fuse with correct rating
Illegal operation Press the RESET button located in the bottom right corner of the front panel
Remote control does not function Battery depleted Replace battery with new one
Battery installed incorrectly Remove battery and install correctly
Poor sound quality or distortion Pirated disc is in use Use original copy
Unit resets itself when engine is off Incorrect connection between ACC and positive battery
wire
Check wiring and correct
Cannot insert disc Disc already inside unit Eject current disc and insert new one
Disc does not play back Disc is warped or scratched Use disc in good condition
Disc is dirty or wet Clean disc with soft cloth
Laser pickup is dirty Clean laser pickup with cleaning disc
Incompatible disc is used Use compatible disc
Disc region code is not compatible with unit Use disc with proper region code
Disc is inserted upside down Insert disc with label side up
Image blurred, distorted, or dark Disc is illegally copied Use original disc
PBC cannot be used during VCD playback PBC is not available on the disc
No repeat or searching while playing VCD PBC is on Turn PBC off