Jensen JE2707 Flat Panel Television User Manual


 
Watching TV
Turning On/Off
Firstly, Plug in the AC power cord to the AC outlet.
Press POWER on the TV or press POWER on the remote control.
The initial setup starts when the TV powers on for the first time. If the TV has been
turned on before, it displays current input signal directly.
Turning On
Turning Off
Press POWER on the TV or press POWER on the remote control.
The TV enters standby mode and the image on the screen disappears.
The TV will still consume some power as long as the AC power cord is still
inserted into the wall outlet.
If you are not going to use this TV for a long period of time, be sure to remove
the AC power cord from the power outlet.
Introducing Channel
Number
This television is capable of receiving the full range of cable-TV channels
available today, from the most digital and HDTV channels, to the traditional
analog channels.
As the transition toward full digital TV continues, some cable-TV systems in the
USA will have a mixture of analog and digital channels in their lineups. So i
ajor channel
number and a minor channel number.
n most
situations the ATSC PSIP channel number is composed of a m
The major channel number is same for
both analog and digital channels (It is equal to the NTSC channel number for
existing broadcasters). An analog channel usually has a minor channel number
of zero, while a digital channel usually has a minor channel number of 1, 2 or
larger.
For analog TV channels
Selecting Channels
You can select analog channels in serveral ways.
Method 1 - Using CH+ or CH- on the remote control or on the TV
Press the CH+ or CH- to cycle among all available channels.
Only those channels marked with a tick symbol can be
selected by the CH+ or CH- button.
Method 2 - Using RECALL on the remote control
Press RECALL to switch to the previously tuned channel.
Press RECALL again to switch back to the currently tuned
channel.
Method 3 - Using 0-9 and OK on the remote control
Press the 0-9 number buttons to input a channel
number and confirm with OK to select up to 125
channels for VHF/UHF/CATV.
Never attempt to move the TV
unless the AC power cord has
been disconnected.
23
CH
+
RECALL
0
1
6
2
9
5 7
3
8
4