JVC 0504CSH-ID-VT DVD VCR Combo User Manual


 
Filename [XV3EX_06Index.fm]
Masterpage:Left+
12 EN
Page 12 August 22, 2003 12:20 pm
INITIAL SETTINGS (cont.)
Preset Download
Auto Channel Set by Downloading
from TV/Auto Clock Set/Auto Guide
Program Number Set
If you have connected the unit to your TV via the AV connection
(
pg. 9), the unit will automatically perform Preset Download
instead of the Auto Set Up in step D on page 11. After
downloading, the unit sets the clock and Guide Program
numbers automatically.
NOTES:
For details, refer to the instruction manual of your TV.
In areas where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto
Clock Set nor Auto Guide Program Number Set.
If there is a power cut, or if you press 1 or SET UP MENU
while downloading or set up is in progress, it will be
interrupted; be sure to turn off the unit power once and try
again from the beginning.
Auto Clock Set may not function properly depending on the
reception condition.
On this unit, the characters available for station names (ID) are
A–Z, 0–9, –,
f, + and I (space). Some names of downloaded
stations may differ from those of your TV. (
pg. 71)
A
Perform Preset Download.
Press OK. The AUTO SET/T-V LINK display appears on
the front display panel and/or on the TV screen.
On the front display panel
Press rt to select “CH – –” and press OK or e.
B
Set the video channel.
Set the video channel to off manually. ( pg. 73)
ATTENTION
You can use this function only with a TV offering T-V Link,
etc.* Be sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may
differ by system.
Slide the TV/VCR/DVD switch to the right.
Perform steps A to C of “Auto Set Up” on page 10 before
continuing.
On the on-screen display
Press rt to move the
highlight bar (pointer) to
“T-V LINK” and press OK or
e.
Preset positions on the front display panel increase from
“CH 1”; do NOT press any button on the unit or remote
control until the front display panel shows clock time,
“(CH) 1” or “– –:– –” as illustrated on page 13.
If you are using the on-screen
display, the T-V LINK screen
will appear. Then the GUIDE
PROG SET screen will appear
during Guide Program
Number Set. When Preset
Download is completed,
“COMPLETED” appears for
about 5 seconds, then the
normal screen appears.
If you press any button on the
unit or remote control while
downloading is in progress, it
will be interrupted.
After “Preset Download” is completed, perform
“Monitor Set (DVD deck)” on page 14.
XV3EX_01.book Page 12 Friday, August 22, 2003 12:21 PM