Filter
Top Products
After a power interruption you must reset the Lock Code.
Write your Lock Code number down and keep it hidden from potential viewers.
If you forget the Lock Code, a new code may be set using the steps listed above.
NOTES:
Set Lock Code
(V-Chip, which appears before Set Lock Code in
the onscreen menu system, is discussed in the
four-page section beginning on page 15).
Channel Guard and V-Chip settings are protected
by a four-digit Lock Code. Your TV comes pre-set
with a Lock Code of "0000". You may change the
code to any four-digit number you wish. To
change the Lock Code, follow the steps below.
P ress the ME N U b u t t o n
To SET LOCK CODE
To operate
The padlock icon appears
Press ZERO to access the Lock Code
The first digit will be highlighted
To select the number
To move to the next digit
Continue to follow these directions for all four
numbers
To FINISH
To save your settings and exit
Channel Summary - Lock
P ress the ME N U b u t t o n
To CHANNEL S U M M A RY
To operate
To the Lock Column
Zero to lock or unlock that channel
Exit when finished
Channel Guard Message
When a viewer attempts to watch a guarded channel,
the following message appears:
To watch a channel that you have locked, enter the
Lock Code using the 10 key pad (see “Set Lock
Code” - at the top of the next column).
If the wrong code is entered, this message will flash
on the scre e n :
The channel cannot be accessed until the corre c t
code is entere d .
• Once a channel has been unlocked, it will
remain unlocked until the television is turned off.
14 Initial Setup
THIS CHANNEL IS LOCKED BY
CHANNEL GUARD.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
NO. - - - -
INVALID LOCK CODE !
LOCK CODE 0 0 0 0
FINISH
THANK YOU !!
CH ADD : CH ADD
0 1 X – : 0 6 X –
0 2 X – : 0 7 –
0 3 X – : 0 8 –
0 4 X – : 0 9 X –
0 5 X – : 1 0 X –