JVC AV-20F476, AV-27F476, AV-32F476 CRT Television User Manual


 
10
These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away.
If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.
Before you can operate your remote control, you first need to install the batteries (included).
Lift and pull the latch on the back of the
remote control to open. Insert two batteries
(included) carefully noting the “+” and “–”
markings, placing the “–” end in the unit first.
Snap the cover back into place.
When you change the batteries, try to
complete the task within three minutes.
If you take longer than three minutes,
the remote control codes for your VCR,
DVD, and/or cable box/satellite receiver
may have to be reset. See pages 18 - 20.
Getting Started
Step 1 – The Remote Control
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television.
The top and bottom buttons will scan forward and
back through the available channels. To move rapidly
through the channels using JVC’s Hyperscan feature,
press and hold CH+ or CH –. The channels will zip by
at a rate of five channels per second. The right and left
buttons will turn the volume up or down. These buttons
are also marked with four arrows and are used with
JVC’s onscreen menu system. To use the onscreen
menus, press the M
ENU button.
Quick Setup Getting Started
MUTING
MENU
C.C.
EXIT
CH +
VOL
VOL
+
C/
CH –
Basic Operation
Turn the television on and off by pressing the POWER button at the top right
corner of the remote. If this is the first time you are turning on the TV, the
interactive plug-in menu appears.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if
you need to operate a cable box.
Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to
DVD to control a DVD player. Please see pages 18 to 21 for instructions on
programming your remote control to operate a cable box, VCR or DVD player.
POWER
VCR DVD
TV
CATV
V
LCT1785-001A-A ENG 10 12/16/04, 2:38:34 PM