JVC AV-20F476, AV-27F476, AV-32F476 CRT Television User Manual


 
24
Initial Setup
Auto Tuner Setup
The auto tuner setup function is described on page 17 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
ENU button
π
To AUTO TUNER SETUP
®
To operate
®
To choose CABLE or AIR
To move to START
®
To start Auto Tuner Setup
Programming will take approximately 1 to 2 minutes. The
auto tuner is finished when the message PROGRAMMING OVER! appears onscreen.
Channel Summary
Channel summary allows you to customize the line-up of channels received by your TV. You
can add or delete channels from the line-up or prevent any unauthorized viewers from watching
any or all 181 channels.
Press the M
ENU button
π
To CHANNEL SUMMARY
®
To operate
The Channel summary screen will now be displayed with
the channels set to scan marked with an “”. You can
delete channels from the scan by removing the “”. If any
channels were missed during auto tuner setup and you
wish to add them, you may by placing an “” next to the
channel number.
π
To the SCAN column
®
To include or delete from scan
π
To the ID column
®
To add channel label
®
To insert letter
To next letter
To move to FINISH when label is complete
®
To memorize the label
Press the E
XIT button when finished
You can block access to a channel by activating the channel lock.
Press the M
ENU button
π
To CHANNEL SUMMARY
®
To operate
π
To the Lock Column ( )
Press the Z
ERO button to lock or unlock that channel
Press the E
XIT button when finished
INITIAL SETUP
>
CHANNEL SUMMARY
1
2
3
4
5
6
7
8
9
10
EXIT BY
EXIT
CH NO. SCAN ID
CH NO SCAN ID
I
I
I
I
I
I
SELECT
BY
OPERATE BY
INITIAL SETUP
>
AUTO TUNER SETUP
START
SELECT
BY
OPERATE BY
EXIT BY
TUNER MODE CABLE
EXIT
INITIAL SETUP
>
CHANNEL SUMMARY
>
ID
EXIT BY
EXIT
SELECT BY
OPERATE BY
RESET BY
0
CHANNEL 02
FINISH
LCT1785-001A-A ENG 24 12/16/04, 2:38:39 PM