Filter
Top Products
10
q
2
3
6
5
/
8
OK
CH
123
456
78
0
9
q65
4
Y
T
2
3
MENU
MENU
INITIAL SETTINGS (cont.)
SELECT D.S.T. MODE
6
You have three choices:
a–Select “AUTO” and the
adjustment to your VCR’s
clock will be made
according to the incoming
signal from the host
channel.
b–Select “ON” and the
adjustment will be made
based on the clock itself.
c–Select “OFF” if Daylight Saving Time doesn’t apply to
you.
Place the arrow next to your choice by pressing
CH
5
∞
, then press MENU and the Semi-Auto Clock Set
screen reappears.
D.S.T. SELECT
=AUTO
ON
OFF
PRESS (
5
,∞) TO SELECT
PRESS (MENU) TO END
NUMBER
OK
CH
Manual
SELECT MODE
2
At the Override Auto Clock Set screen, place the
arrow next to “MANUAL CLOCK SET” by pressing
CH▲▼, then press OK.
SET DATE, TIME AND D.S.T.
3
The Manual Clock Set
screen is displayed and the
first setting that can be set
begins flashing. Press the
appropriate NUMBER keys
to set the date and time (if
only 1 digit, press "0" first).
Press CH▲▼ to set AM/
PM and D.S.T. (Daylight
Saving Time) to “ON” (automatic adjustment based on
VCR’s clock) or “OFF” (if D.S.T. does not apply to you).
Press OK after AM/PM and D.S.T. settings. The next
setting that can be set begins flashing. When you’re
finished with this set-up procedure, press MENU to start
the clock.
NOTE:
CH
▲▼
can be used to perform all operations. (In this
case, press OK after each setting.)
MAKE CORRECTIONS
4
To change any of the settings, press OK until the item
you want to change blinks, then set as in step 3.
MANUAL CLOCK SET
DATE 1/ 1/96 MON
TIME – – : – – AM
D.S.T. ON
PRESS NUMBER KEY(0-9)
OR (
5
,∞), THEN (OK)
PRESS (MENU) TO END
IMPORTANT
After performing the Semi-Auto clock set procedure, make
sure that the VCR is off before the next hour so that the clock
can be set. (The clock is automatically adjusted on the hour
except at 11:00 PM, midnight, 1:00 AM and 2:00 AM.)