Filter
Top Products
25
q
2
3
6
5
/
8
MENU
123
456
78
0
9
q65
4
Y
T
2
3
OK
OK
MENU
CH
CH
TIMER
NUMBER
NUMBER "9"
NUMBER "8"
SELECT PROGRAM
NUMBER
3
Press the appropriate NUMBER keys or CH
5
∞
to select
a vacant program number, then press OK. The first time
you do this, all numbers will be vacant, so just press
OK when the screen appears.
SET PROGRAM
INFORMATION
4
Press the appropriate NUMBER keys to set the date,
start/stop time and channel number. Press CH
5
∞
to set
AM/PM and tape speed. Then press OK after AM/PM,
channel number and tape speed settings. The next
setting that can be set begins flashing.
● Any information comprised of 1 digit (except the
channel number) should have a "0" entered before it.
● It is possible to set all information using the CH
5
∞
buttons. (In this case, press OK after each setting.)
NOTE:
If you are using a cable box, enter the cable box
channel, not the channel to be recorded. The channel
to be recorded must be selected on the cable box. (The
cable box channel is the VCR's channel that displays
the channels received by the cable box.)
**You can record selected programs at the same time
every weekday, or once a week. Before entering the
month, press NUMBER key “8” (DAILY) or “9”
(WEEKLY). Either "DAILY" or "WEEKLY" appears.
Press again and "DAILY" or "WEEKLY" disappears.
MAKE CORRECTIONS
5
To change any of the settings, press OK until the item you
want to change begins blinking. Then set as in step 4.
RETURN TO NORMAL
SCREEN
6
Press MENU as many times as necessary.
● Press just once to access the Auto Timer screen
(੬ pg. 27).
ENGAGE TIMER MODE
7
Press TIMER. The VCR turns off automatically.
EXAMPLE
If you program the VCR to timer
record a show on September 6
on channel 40 from 12:00 noon
to 1:00 PM in SP mode, the
screen will look like this:
PROGRAM 1
DATE 9/ 6 SUN
START 12:00 PM
STOP 1:00 PM
CHANNEL 40 SP
PRESS NUMBER KEY(0-9)
OR (
5
,∞), THEN (OK)
PRESS (MENU) TO END
NOTES:
●
To disengage the timer before recording starts, press TIMER
again. Pressing once more re-engages it.
●
In case of a power failure after programming, the VCR’s
memory backup keeps your selections for 10 minutes.
●
If you select "PROGRAM SET" without having set the date and
time, an error message appears. Follow its instructions.
●
If you enter a start time that has already passed, ERROR
appears on the screen and flashes.
●
Programs that start after midnight must have the next day’s
date.
●
After timer recording is completed, the VCR’s power goes off
automatically.
●
You can program the timer while a regular recording is in
progress; the on-screen menu will not be recorded.
●
If the end of tape is reached during timer recording, the
cassette is automatically ejected.
●
When timer-recording cable channels received through a
Cable Box, be sure to keep the Cable Box set to ON.