Filter
Top Products
35
Receiving NICAM Stereo
And Bilingual Programmes
(HR-J745EK Only)
Your recorder is equipped with a Digital stereo sound decoder
(NICAM), making reception of stereo and bilingual broadcasts
possible.
When the recorder is tuned to a different station, the type of
broadcast being received will be displayed on the TV screen for
a few seconds.
To Record NICAM Stereo
And Bilingual Programmes
(HR-J745EK Only)
The NICAM audio programme will be recorded on the Hi-Fi
audio track, and the Standard audio programme on the normal
audio track.
NOTES:
●
If the quality of stereo sound being received is poor, the
broadcast will be received in monaural with better quality.
●
Before playing back a programme recorded in stereo, or a
bilingual programme, refer to "Soundtrack Selection" (
੬
pg. 16).
Type of Broadcast
On-screen Display
Being Received
Regular Monaural (none)
NICAM Stereo ST NICAM
NICAM Bilingual BIL NICAM
NICAM Monaural NICAM
NOTE:
"O.S.D." must be set to "ON" or the on-screen displays will not
appear (
੬
pg. 34).
● To listen to a stereo programme, press AUDIO MONITOR
until "L" and "R" appear on the front display panel.
● To listen to a bilingual programme, press AUDIO MONITOR
until either "L" or "R" appears on the front display panel (as
required).
● To listen to the Standard (regular monaural) audio while
receiving a NICAM broadcast, press AUDIO MONITOR until
"NORM" appears on the front display panel.
Tape Position Indicator
The tape position indicator
appears on screen when, from
the Stop mode, you press FF,
REW or perform an Index
Search. The position of “5” in
relation to “0” (beginning) or
“+” (end) shows you where you
are on the tape.
”O.S.D.” (੬ pg. 34) must be
set to “ON”, or the indicator
will not appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
3
1:23:45
REMAIN 2:35
0
+++
Beginning End
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET A/B CODE SWITCH
2
Set to B.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press on the remote control. The recorder will now
only respond to B code signals.
NOTE:
Some TV sets may malfunction in response to the B mode. If
this happens, switch back to the A mode.