JVC HR-J255EK VCR User Manual


 
23
This facility allows you to record automatically a satellite
programme which is timer-programmed on your external
satellite receiver. Connect a satellite receiver to the recorder's
AV2 IN connector and programme the timer on the satellite
receiver; the recorder starts recording when the signals input
from the satellite receiver to the AV2 IN connector, and when
there is no input signals the recorder stops recording and the
power shuts off.
Automatic
Satellite
Programme
Recording
ATTENTION
Be sure not to turn on the satellite receiver before the
programme is executed; otherwise, the recorder will start
recording when the satellite receiver's power is turned on.
If you have connected another appliance other than a
satellite receiver to the AV2 IN connector, be sure not to
engage the Auto Satellite Prog Rec mode; otherwise, the
recorder will start recording when the connected
appliance's power is turned on.
Auto Satellite Prog recording and timer-recording cannot
be done at the same time.
Before performing the following steps:
Make sure the satellite receiver is connected to the
recorder's AV2 IN connector. ( pg. 29)
Programme the timer on the satellite receiver.
Insert a cassette with the safety tab in place.
SET TAPE SPEED
1
Press SP/LP ( ) to set the tape speed.
ENGAGE AUTO SATELLITE
PROG REC MODE
2
Press and hold REC LINK for about 2 seconds. The REC
LINK indicator lights up and the recorder turns off
automatically.
To disengage the Auto Satellite Prog Rec mode, press
REC LINK. The REC LINK indicator goes off.
If the recorder's power is off, it is not possible to
engage the Auto Satellite Prog Rec mode.
NOTES:
Auto Satellite Prog recording is not possible with the AV1 IN/OUT connector.
When the Auto Satellite Prog Rec mode is engaged or the recorder's power is turned off after Auto Satellite Prog recording is
finished, the recorder will not enter the Timer mode even though "AUTO TIMER" is set to "ON".
After Auto Satellite Programme recording, the number of recorded programmes will not be displayed on the front display panel for
the Instant ReView function (
pg. 19).
For timer programming of the satellite receiver, refer to the instruction manual of the satellite receiver.
Auto Satellite Prog recording is not possible if your satellite receiver does not have a timer.
The REC LINK indicator blinks while Auto Satellite Prog recording is in progress.
Pressing the recorder's button while Auto Satellite Prog recording is in progress turns off the recorder's power and disengages
the Auto Satellite Prog Rec mode.
If there is more than one satellite programme you wish to record with Auto Satellite Prog Recording, it is not possible to set a
different tape speed for each; the tape speed selected in step 1 will apply to all the programmes for Auto Satellite Prog recording.
The B.E.S.T. system (
pg. 20) does not work while Auto Satellite Prog recording is in progress.
Just Clock (
pg. 37) does not work when the Auto Satellite Prog Rec mode is engaged.
Depending on the type of satellite receiver, the recorder may not record a short portion at the beginning of the programme or may
record slightly longer than the actual length of the programme.
If you engage the Auto Satellite Prog Recording mode when the satellite receiver's power is on, the recorder will not start Auto
Satellite Prog recording even though the REC LINK indicator blinks. When the satellite receiver shuts off once and is turned back
on again, the recorder starts recording.
You can also record a programme from your cable system in the same way if the system has a timer and is connected to the
recorder's AV2 IN connector.
SP/LP
REC LINK
REC LINK indicator