Filter
Top Products
7
The channel on which the screen in item
2
appears clearly is your Video Channel.
To view picture signals from the video recorder, set your TV to the Video Channel.
AFTER YOU FINISH THIS STEP
Go to Step 4 – AUTO SET UP
IMPORTANT
Ⅲ If you set the video recorder to a channel which is occupied by a local station or has neighbouring channels that are occupied
by local stations, the picture reception quality will be affected and some interference noise will appear on the TV screen. Be
sure to select a vacant channel which has no broadcast on neighbouring channels.
Ⅲ If you cannot obtain the two vertical white bars clearly with any channel between 28 and 60, consult your JVC dealer.
Before performing the following procedure, make sure that:
Ⅲ the mains power cord is plugged into the mains outlet.
Ⅲ the video recorder is turned off and there is no cassette inserted in
the recorder.
Ⅲ the connected TV is turned on.
Ⅲ batteries have been installed in the remote control.
With RF Connection
1
Press and hold down STOP(5/8) on the recorder until the display
panel shows the following.
2
Set your TV to UHF channel 52. (Refer to the instructions supplied
with your TV set for how to do this.)
● If the two vertical white bars appear clearly
on the screen as shown to the right, go to
item 3.
● If the two vertical white bars do not appear clearly, press TV
PROG + or – to set the video recorder to a vacant channel
between 28 and 60 which is not occupied by any local station in
your area.
Refer to list on page 36 for details of broadcast stations in your
area.
(Ex.) If channel 36 is available in your area.
Then set your TV to UHF channel 36 and check if the two vertical
white bars appear clearly on the screen; if so, go to item 3. If not,
re-set the video recorder to another vacant channel and try again.
3
Press to turn off the recorder.
123
456
7
89
0
2
4
1
3
?