JVC HR-J255ES VCR User Manual


 
27
Auto Timer
When the Auto Timer is set to ON the timer is automatically
engaged when the recorder power is turned off and automati-
cally disengaged when the recorder is powered back on.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS MODE SET SCREEN
2
Press %fi to place the
pointer next to "MODE
SET", then press OK or .
SELECT MODE
3
Press OK or to select
either "ON" or "OFF".
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTE:
For safety, when Auto timer is set to "OFF", all other recorder
functions are disabled while the Timer mode is engaged. To
disengage the timer, press
.
MAIN MENU
MODE SET
AUTO CH SET
MANUAL CH SET
INITIAL SET
[5
] =
[MENU] : EXIT
%
Auto SP
LP Timer
If, when timer-recording in SP mode, there is not enough tape to
record the entire programme, the recorder automatically
switches to LP mode to allow complete recording.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-
minute tape
NOTES:
The Auto SP
LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 or with some tapes
of shorter lengths.
If you have programmed the recorder to timer-record 2 or more
programmes, the second programme and those thereafter may
not fit on the tape if you set "AUTO SP
LP TIMER" to "ON". In
this case, make sure the mode is not engaged, then set the tape
speed manually during timer programming.
In order to ensure that the recording fits on the tape, this
feature may leave a short non-recorded section at the end of
the tape.
There may be some picture noise and sound disturbance at
the point on the tape where the recorder switches from SP to
LP mode.
If you perform timer recording with both PDC and the Auto
SP
LP Timer activated, and the programme goes beyond its
originally scheduled length, there may be times when the
programme cannot be recorded in its entirety.
Total 210 minutes
Approximately 150 minutes Approximately 60 minutes
SP mode LP mode
%
Make sure you set "AUTO SPLP TIMER" to "ON" at the Mode
Set screen before the timer-recording starts.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS MODE SET
SCREEN
2
Press %fi to place the pointer next to "MODE SET",
then press OK or .
SELECT MODE
3
Press %fi to place the
pointer next to "AUTO
SPLP TIMER", then press
OK or to select "ON".
RETURN TO NORMAL
SCREEN
4
Press MENU.
%
%
MODE SET
AUTO TIMER OFF
O. S. D. ON
B. E. S. T. ON
AUTO SP=LP TIMER ON
[5
] =
[MENU] : EXIT
MODE SET
AUTO TIMER OFF
O. S. D. ON
B. E. S. T. ON
AUTO SP=LP TIMER OFF
[5∞] =
[MENU] : EXIT