Filter
Top Products
9
Auto Set Up results appear on the display panel
When both auto channel set and auto clock set have been
completed successfully the correct current time will be
displayed.
When auto channel set has been completed successfully but
auto clock set has not, "(PR)1" will be displayed.
When neither auto channel set nor auto clock set has been
completed successfully, "--:--" will be displayed.
* You can check if the Guide Program numbers have been set correctly when you perform Video Plus+ Timer Programming
(
੬ pg. 14); if the correct preset position number is displayed in step 3, this confirms that the Guide Program number for the
PlusCode number you enter in step 2 has been set correctly.
A If both auto channel set and auto clock set have been performed successfully:
1
Turn on the TV and select its VIDEO channel or AV mode, then make sure that all necessary stations have been stored in the
recorder's memory by using the TV PROG button(s).
● If station names (ID — ੬ pg. 35) have also been stored in the recorder's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds each time the recorder is tuned to a different station.
● If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station
names, see pages 32 – 34.
Now you have finished the basic set up and can use your recorder for both playback and recording.
B If auto channel set has succeeded but auto clock set has not:
1
Turn on the TV and select its VIDEO channel or AV mode, then make sure that all necessary stations have been stored in the
recorder's memory by using the TV PROG button(s).
● If station names (ID —
੬ pg. 35) have also been stored in the recorder's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds each time the recorder is tuned to a different station.
● If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station
names, see pages 32 – 34.
2 Perform "Clock Set" on page 37.
Now you have finished the basic set up and can use your recorder for both playback and recording.
C If both auto channel set and auto clock set have failed:
1
Make sure the TV aerial cable is connected properly to the recorder and turn off the recorder power once, then turn the
recorder power back on again.
● The recorder will try Auto Set Up again.
A
B
C
If you have any difficulty with the above procedures call the JVC Customer Service Hot Line
on 0181 208 7654