Filter
Top Products
EN 25
RETURN TO NORMAL
SCREEN
5
Press PROG or OK. "PROGRAM COMPLETED" appears
on the screen for about 5 seconds, then normal screen
appears.
● Repeat steps 1 – 5 for each additional programme.
ENGAGE RECORDER'S
TIMER MODE
6
Press
‰‰
‰‰
‰. The recorder turns off automatically and "‰"
appears on the display panel.
● To disengage the timer, press
‰‰
‰‰
‰ again.
NOTES:
●
To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays this
way.
●
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
"9") for weekly serials or DAILY (NUMBER key "8") for daily
serials (Monday – Friday). Either "WEEKLY" or "DAILY" appears
on the screen. Pressing the button again makes the corre-
sponding indication disappear.
●
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
੬
pg. 28).
●
It is not possible to timer-record a TV programme with a
G-
CODE
number which starts with "0".
ATTENTION
Regarding Guide Program Number Set
"G-CODE/SHOWVIEW SETUP" appears after performing
step 3 if the Guide Program number for the G-CODE number
you entered has not been set.
● Press the NUMBER keys or PUSH JOG %fi to input the
channel position number on which your recorder
receives that station, then press OK or PUSH JOG .
The G-CODE program screen appears.
(Ex.) To timer-record a RTR
programme with the G-CODE
System.
* If your recorder receives
RTR on the channel position
2, press OK or PUSH JOG
after entering "2".
Satellite Tuner Users
To timer-record a satellite broadcast using the G-CODE
System:
1 Perform steps 1 – 6.
2 Set the satellite tuner to the appropriate channel before
the selected programme begins.
3 Leave the satellite tuner's power on.
%
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2– –
[0-9] OR [
5
/
∞
]:SELECT =
[PROG] : EXIT
123
456
7
89
0
1
2
4
3
PUSH JOG
OK
NUMBER
DAILY
WEEKLY
STOP+/–
PROG
%