JVC HR-S6953EU VCR User Manual


 
Masterpage:Right-Full-NoTitle0
EN
49
Filename [HRS6950EU4-EN.fm]
Page 49 April 11, 2002 8:46 am
* The default setting is bold in the table below.
8
POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the power consumption
while the recorder is turned off.
NOTES:
During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
pg. 58) does not work.
... the picture may be distorted momentarily when you turn on/off the recorder.
Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder’s power is turned off after timer-recording or Instant Timer Recording.
... the Automatic Satellite Programme Recording mode is engaged (
pg. 33).
... “L-2 SELECT” is set to “DECODER” or “SAT” (
pg. 41).
8
VIDEO STABILIZER
ON
OFF
When this function is set to “ON”, you can automatically correct vertical
vibration in the picture when playing back unstable recordings made on
another recorder.
NOTES:
When you finish viewing a tape, be sure to set this function to “OFF”.
Regardless of the setting, this function has no effect during recording and during
special effects playback.
The on-screen display may jitter vertically when this function is set to “ON”.
To watch recordings with close-caption, set this function to “OFF”.
8
S-VHS
ON
OFF
Your recorder can record in S-VHS (Super VHS), S-VHS ET or VHS.
To record in S-VHS:
Set “S-VHS” to “ON”. Then, insert a cassette marked “S-VHS”. The S-VHS
indicator lights up on the front display panel.
The S-VHS recording mode is selected.
To record in S-VHS ET on a VHS cassette:
See “Super VHS ET (S-VHS ET)” on page 24.
To record in VHS:
Insert a cassette marked “VHS”.
Press S-VHS ET on the recorder. You can check the current setting (“S-VHS ET
: ON” or “S-VHS ET : OFF”). If “S-VHS ET : ON” appears on the TV screen,
press S-VHS ET again in about 5 seconds to set it to “OFF”.
The VHS recording mode is automatically selected regardless of the “S-VHS”
mode setting.
To record in VHS on an S-VHS cassette:
Insert a cassette marked “S-VHS”. The S-VHS indicator lights up on the front
display panel. Then, set “S-VHS” to “OFF”. The S-VHS indicator goes off.
The VHS recording mode is selected.
NOTE:
When playing back a tape that has been recorded in S-VHS or S-VHS ET, the S-VHS
indicator lights up on the front display panel regardless of the “S-VHS” mode setting.
HRS6950EU4-EN.fm Page 49 Thursday, April 11, 2002 8:46 AM