Filter
Top Products
34 EN
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET REMOTE CONTROL
CODE
2
Press and hold VCR on the remote control for over 2
seconds, press the NUMBER key "2" and then press OK.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step 2.
SPECIAL FEATURES
Remote
Control
Functions
1 2 3
4 5 6
7 8 9
1
2
3
4
1
2
3
4
– –:– –
0
VCR
NUMBER "1"
NUMBER "2"
OK