JVC HR-DD845EK VCR User Manual


 
27
ENTER PRESET POSITION
6
Press TV PROG +/–.
IMPORTANT
Be sure to confirm the setting of PDC recording.
If " ON" is displayed on the screen or " " is lit
on the display panel, PDC is set to ON.
If " OFF" is displayed on the screen or " " is
not lit on the display panel, PDC is set to OFF.
To change the setting, press : PDC (NUMBER key
"7").
"PDC Recording" on page 26.
SET TAPE SPEED
7
Press SP/LP ( ) to set the tape speed.
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
Repeat steps 18 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
9
Press TIMER. The recorder turns off automatically.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday – Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
q
12
45
3
6
8
0
7
9
2
4
1
3
OK
WEEKLY
TIMER
SP
: PDC
– P1 –
START STOP
21:00 = 22:00
SP OFF
DATE TV PROG
25.12 1
BBC 1
[+/–] =
[MENU] : EXIT
SP/LP
7
TIMER
9
8
9
DAILY
NOTES:
You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen and "FULL"
appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
pg. 28).
To timer-record a satellite broadcast through a satellite
receiver connected to the AV2 IN connector on the back of
the recorder, in step 6 above, set "TV PROG" to "AUX2" by
pressing TV PROG +/–. Before the selected programme
begins, select the appropriate channel on the satellite
receiver, then set the receiver's timer. If your satellite receiver
doesn't have a timer, leave the unit's power switched on.
TV PROG
6