JVC HR-DD845EK VCR User Manual


 
39
12
45
3
6
8
0
7
9
2
4
1
3
NUMBER
TV/SAT/VCR
STOP
Satellite Receiver Multi-
Brand Remote Control
Your remote control can operate the basic functions of your
satellite receiver set. In addition to JVC satellite receivers, other
manufacturer’s satellite receivers can also be controlled by setting
the appropriate switch on the remote control.
Before you start . . .
Turn on the satellite receiver using its remote control.
Set the remote control’s TV/SAT/VCR switch to SAT
SET SATELLITE RECEIVER
BRAND CODE
1
Refer to the chart below. While holding down ,
enter your satellite receiver’s brand code using the
NUMBER keys, then press STOP.
Some satellite receiver brands have more than one
code. If the satellite receiver does not function with
one code, try entering another.
You don’t have to repeat this step until you replace
your remote control’s batteries.
TRY OPERATING SATELLITE
RECEIVER
2
Press on the remote to turn the satellite receiver off.
If it goes off, try other operations.
The button, TV PROG +/– button, NUMBER
buttons on the remote can all be used to operate the
satellite receiver.
The NUMBER buttons will not work with JVC satellite
receivers using code 13.
With satellite receivers using Code 16, the
button corresponds to the ENTER button of your
satellite receiver’s remote control.
To return the remote to video recorder control, set its
TV/SAT/VCR switch to VCR.
IMPORTANT
Although the provided remote control unit is compatible with
JVC satellite receivers, as well as many other models, it may not
work with your satellite receiver, or in some instances, may
have limited function capability.
SATELLITE RECEIVER BRAND CODE
JVC 13, 14
AMSTRAD 01, 02, 03, 04
SIEMENS 05
GRUNDIG 05, 06
KATHREIN 05, 11, 12
PACE 06, 08
PHILIPS 07
ITT 09
NOKIA 09
SKYMASTER 10
RFT 10
MASPRO 11
BT 13
PANASONIC 15
JERROLD 16
TV PROG