Filter
Top Products
EN 17
Reverse Forward
Search Play Slow-Motion *Still Slow-Motion Play Search
SP -9x -7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x 9x
LP -7x -3x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 5x 9x
NTSC SP/EP -7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x
Audio output Audio is output.
Audio is not Audio is Audio is not
Audio is output.
output. output. output.
TimeScan
* Still mode cannot be engaged using the remote control's PUSH JOG or button. Still mode can only be
engaged by pressing the PAUSE button.
● The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
● To resume normal playback, press PLAY.
● When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change in the correct step if it is turned
too fast.
● Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
● The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
● During high-speed search with an NTSC tape containing both SP and EP recordings, the search speed will change
automatically to 7x normal playback speed with TimeScan when the recording tape speed switches from EP to SP.
● Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search, or
depending on the tape being used.
● Picture may appear distorted in comparison to normal playback.
● In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
● TimeScan sound quality will differ in comparison to normal playback.
● When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 2x
normal speed, the audio playback may be faster than normal.
● When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
● There will be a loss of colour or the picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
If you don't want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF" (See below).
TimeScan Audio
The audio output can be set ON/OFF during TimeScan. Select ON/OFF as required.
* The default setting is "ON".
1 Press MENU to access the Main Menu screen.
2 Place the pointer next to "FUNCTION SET" by pressing PUSH JOG %fi, then press OK or
PUSH JOG .
3 Place the pointer next to "TIME SCAN AUDIO" by pressing PUSH JOG %fi, then press
OK or PUSH JOG to select "ON" or "OFF".
4 Press MENU to return to the normal screen.
%
%
%
fi
FUNCTION SET
AUTO TIMER OFF
O.S.D. ON
B.E.S.T. ON
AUTO SP=LP TIMER OFF
TIME SCAN AUDIO ON
[5/
∞
] =
[MENU] : EXIT
Names of
special-effects
playback
PAL/
MESECAM