Filter
Top Products
EN 11
T-V LINK
T-V Link
Functions
TURN ON THE RECORDER
1
Press .
ACCESS MAIN MENU
SCREEN
2
Press MENU.
ACCESS MODE SET
SCREEN
3
Press %fi to move the
highlight bar (pointer) to
"MODE SET", then press
OK or
#
.
SELECT DIRECT REC MODE
4
Press %fi to move the
highlight bar (pointer) to
"DIRECT REC", then press
OK or
#
to set to "ON".
RETURN TO NORMAL
SCREEN
5
Press MENU.
NOTES:
• If "DIRECT REC" is set to "OFF", the RECORD button functions
as described in "Basic Recording" (
੬
pg. 17) .
• During the Direct Rec, "CH – –" appears on the display panel.
• When you perform T-V LINK functions, be sure to use the
fully-wired 21-pin SCART cable.
MAIN MENU
MODE SET
AUTO CH SET
MANUAL CH SET
CLOCK SET
[
5
∞
] =
[MENU] : EXIT
MODE SET
B. E. S. T. ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
O. S. D. ON
DIRECT REC ON
POWER SAVE ON
COLOUR SYSTEMPAL/NTSC
[5∞] =
[MENU] : EXIT
NexTView Link
You can download the EPG (Electronic Programme Guide)
information from your TV for timer-programming on the
recorder.
For details, refer to the instruction manual for your TV.
TV Auto Power On
You can turn on the TV and set it to video mode automatically
whenever you play a tape.
For details, refer to the instruction manual for your TV.
VCR Auto Standby
You can use your TV's remote control to turn off the recorder.
For details, refer to the instruction manual for your TV.
When you connect the recorder and your TV via fully-wired
21-pin SCART cable (੬ pg. 3), the following functions are
available. You can use these functions only with the TV offering
T-V Link, etc.*
For details, refer to the instruction manual for your TV.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-
wired 21-pin SCART cable. The degree of compatibility and
available functions may differ by system.
Direct Rec
You can start recording the programme that you are watching
on your TV with simple operation. Press and hold RECORD and
press PLAY on the remote control, or press RECORD on the
recorder.
Follow the procedure below to use this function.