JVC HR-J443U VCR User Manual


 
EN 37
3
78
1
¡
1
2
3
456
7
8
0
9
POWER
TIMER
A/B
NUMBER "1"
NUMBER "2"
UNPLUG VCR'S POWER
CORD
1
Unplug from the AC outlet.
SET REMOTE CONTROL
CODE
2
While holding down A/B on the remote control, press
the NUMBER key "2" and then press STOP.
PLUG IN POWER CORD
3
Plug back in to the AC outlet.
TURN VCR POWER ON
4
Press POWER on the remote.
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B.
Control Two JVC VCRs
The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's A
code control signals and another set to respond to B code
control signals. The remote control is preset to send A code
signals because your VCR is initially set to respond to A code
signals. You can easily modify your VCR to respond to B code
signals.
TURN VCR POWER ON
1
Press POWER.
ENGAGE CHILD LOCK
2
Press and hold POWER on the remote control until the
Child Lock indicator ("—") appears on the front display
panel.
Power turns OFF and the VCR cannot be turned on
from the POWER button on the front panel.
To cancel Child Lock, press and hold POWER on the
remote to turn the VCR on. During timer recording,
pressing TIMER also cancels Child Lock.
NOTES:
When Child Lock is engaged, make sure to keep the remote
control out of the reach of children.
Timer recording of programs that were previously set can be
performed while the Child Lock is engaged. The feature
remains in effect after the recording is finished.
Child Lock
This feature allows you to prevent the operation of the VCR.
STOP